2017 Mercedes-Benz E300
Mileage
59,882
Service Date
6/8/2022
Services Performed
- SPARK PLUGS – Remove & Replace
- TRANSMISSION OIL PAN GASKET &/OR FILTER – Remove & Replace – [Includes: Additional time for use of scan tool to perform this procedure.]
- The first Service A is due at 10000 miles or 12 months, then every 20000 miles or 24 months. TIRE PRESSURE MONITORING SYSTEM SENSORS – ACTIVATE WATER DEFLECTOR – CLEAN – [Clean visible area of water deflector.] BRAKE FLUID – INSPECT – [In the event of fluid loss, determine cause and perform repair.] BRAKE SYSTEM – INSPECT – [Visually check condition of brake pads/linings, condition of brake disks.] COOLANT LEVEL – INSPECT – [Check coolant level in coolant expansion tank.] HORN OPERATION – INSPECT – [Check horn for correct function.] PARKING BRAKE – INSPECT – [Function test only: Vehicles with 4MATIC: If brake test is carried out on a dynamometer, the brake test may not exceed 10 seconds on each axle. You could otherwise damage the drive train or the brake system.] TIRES – INSPECT – [Correct tire inflation pressure, Correct inflation pressure in spare tire (where applicable). Check TIREFIT sealant expiration date (where applicable). If expired, replace it. Activate Tire Pressure Monitoring System.] TRUNK LIGHTING – INSPECT – [Check trunk/cargo compartment lighting for correct function.] VEHICLE – INSPECT – [Check vehicle's exterior for damage in visible area.] WARNING & INDICATOR LAMPS – INSPECT – [Inspect warning and function indicator lamps in the instrument cluster. Check illumination of the instrument cluster and interior lighting for correct function.] WINDSHIELD – INSPECT – [Check for damage.] AIR FILTER – REPLACE – Activated Charcoal Filter ENGINE OIL – REPLACE ENGINE OIL FILTER – REPLACE SERVICE INTERVAL INDICATOR/DISPLAY – RESET – [Read out service data from instrument cluster and reset ASSYST PLUS service interval display. If the service/maintenance work has not, or has only partially been carried out after the ASSYST PLUS service interval display has been reset, the maintenance computer must be reset to its original settings.]
- VERIFIED COMPLAINT, RAN ENGINE TEST FOUND CODE P001686 THE POSITION OF THE INTAKE CAMSHAFT CYLINDER BANK 1 IS IMPLAUSIBLE RELATIVE TO THE POSITION OF THE CAMSHAFT, REMOVE VALVE COVER AND CHECK BASIC TIMING POSITION AND IS OFF, REPLACE INTAKE CAMSHAFT AND SPROCKET, ERASE CODE AND RE LEARN CAMSHAFT, CHECK OK AT THIS TIME
DITRA P. gave our service a 5 star review on 6/13/2022
